Acceptance: Each cylinder is tested to Brant standards. Cylinders whose application data lies outside the stated values can be offered as a special version. For assembly, commissioning and maintenance cylinders, please contact us for more details. Cylinders with pivot mountings, which absorb forces on their centreline, should be used for applications where the machine member to be moved travels in a curved path. They may be used for tension pull or compression push applications.
Fixed clevis mounting cylinders MP3 may be used if the curved path of the piston rod travel is in a single plane; for applications where the piston rod will travel in a path either side of the true plane of motion, the spherical bearing mounting MP5 is recommended. These cylinders are designed to absorb force on their centre-lines.
They are suitable for tension pull or compression push applications, and may be used where the machine member to be moved travels in a curved path, in a single plane. Trunnion pins are designed for shear loads only and should be subjected to minimum bending stresses. MS2 cylinders do not absorb forces on their centreline. As a result, the application of force by the cylinder produces a turning moment which attempts to rotate the cylinder about its mounting bolts. It is important, therefore, that the cylinder should be firmly secured to the machine member on which it is mounted and that the load should be effectively guided, to avoid side loads being applied to the rod gland and piston bearings.
This mounting style is used for straight line force transfer applications in which the cylinder being pulled. The mounting flange surface should be flat, and the rod end should be piloted into it. The frame on which the cylinder is mounted must be sufficiently rigid to resist bending moments resulted from lateral force. Inquiry Catalog.
Cylinders with side foot Basic version! Bore non-compliant with ISO standard. Unless otherwise specified, all dimensions are given in millimetres. Hydraulic and pneumatic cylinders. Side foot! Intermediate fixed trunnion! Rear clevis! Rear spherical bearing!
Double rod basic version! Double rod side foot! Double rod intermediate fixed trunnion! All dimensions are given in millimetres. Fork joint hinge with pin ISO ! Weights of the 09 series Note the bore, diameter of rod, mounting type and stroke, the total weight of the cylinder is calculated by adding the weight in Kg according to mounting type at blank stroke to the weight for each 10 mm of stroke, multiplied by the stroke in cm. Inductive proximity sensors The end-of-stroke sensors use technology of the Hall effect inductive type for reading and can be mounted both on the head and the cap as long as the mounting and other types of connection present on the same side allow for this in accordance with information given in Table 13 on page The sensors can be applied to all mounting types of ISO cylinders and to both heads for every available bore.
Your most recent searches Delete. Frequent searches. Other sections. ISO 39 Pages Add to favorites. Catalog excerpts. Open the catalog to page 2. Open the catalog to page 3.
0コメント